So we’re getting closer to the end of this project, hopefully, here I solder the master section and I try to power it up for the first time and see if I get any sound at all from it.
Soldering the I/O board of the E-Licktronic Nava TR-909 clone. The only issue here was that the DIN connectors did not have the correct spacing between the outer pins so I had to modify them as I did not want to wait for “proper ” ones. This worked out fine!
This video shows the soldering and troubleshooting of the E-Licktronic Nava Sequencer section. The biggest issue I had here was that the supplied LED holders were too big and did not fit side by side. I resolved this by using some 10MM high M3 spacers that I had. These fit perfectly; You just have to…
Soldering the Middle Tom of the E-licktronic Nava Roland TR-909 clone. I discovered that I by mistake had used the wrong type of capacitors in the power supply (but the correct value). Some of these capacitors were needed in the Middle Tom section so I had to desolder and rework the power supply.
