Building the Nava #12 – Soldering the Sequencer

This video shows the soldering and troubleshooting of the E-Licktronic Nava Sequencer section. The biggest issue I had here was that the supplied LED holders were too big and did not fit side by side. I resolved this by using some 10MM high M3 spacers that I had. These fit perfectly; You just have to push the LED legs together slightly to fit in the screw hole. Be careful so the legs do not touch while mounted inside the spacer.

Nylon spacers used as holders for the LEDs
Top side
Bottom side. Please note that the big connector is mounted uside down here; this was corrected later on

Related posts

Leave a Comment

This site uses Akismet to reduce spam. Learn how your comment data is processed.